Zurück zu: Perfusionssysteme für schnellen Lösungsaustausch

RSC-200

DruckenShare
Perfusions-System (BioLogic)
BioLogic  RSC-200   Perfusion System
Beschreibung
  1. Command box
  2. Stepping motor
  3. Rotating head (4 to 36 holes)
  4. Set of tubing
  5. Set of syringes
  6. Micromanipulator
  7. Magnetic stand
  8. Rack with 9 electrovalves
  9. Syringe rack holder

 

Unique features:

 

Introduction on RSC operation

Change of concentration of ion, neurotransmitters or of all possible sort of ligands to be tested is an important issue in modern patch-clamp recordings. The Bio-Logic Rapid Solution Changers are the simplest and easiest-to-use systems to achieve this goal.

These instruments use the principle known as "sewer pipes" in which the cell or the tip of the electrode (in excised-patch mode) is positioned close to the output of a capillary. The solution to be assayed is flowing out of the capillary at a moderate flow rate. The cell, being exposed in this stream, very rapidly equilibrates in the perfusion solution.

The fact that all solutions are flowing in individual tubes right to their end eliminates all problems of dead volumes, washing and cross-contaminations between solutions to be assayed (1,2). This perfusion principle has been used in many laboratories where it has been proved that it was a very adequate system for solution assays.

Fast and automated solution change:

The solutions to be assayed are driven to the rotating head of the RSC. The solution exchange is performed by a very precise rotation of the RSC head which exposes the patch pipette or the cell to the flow of one of the tubes. Times of rotation from one tube to the adjacent one can be programmed from 2 to 800 ms. The motor is light and vibration free thanks to the disk rotor technology and to the micro step command delivered by the controller. Due to the high number of tubes it is possible to have one tube for every solution to be assayed. As compared to fixed tube devices, the rotating head permits a fast change of the perfusion solution around the patch pipette without any contamination from the previous solution at the time of solution switching.


Command box



Rotating straight head (9 holes)

 

Specifications  (RSC-200):

Tube control:      up to 36

Valve or motorized syringes control (with optional EVH-9 or MS-x Unit(s)):    up to 36 (with 4 × EVH-9 or 4 × [MS-1 + MS-8])

Built-in stimulator:    Yes

GPIB interface:    Yes

 

Ordering information

The RSC-200 are delivered complete with: command box, stepping motor, driving software, one syringe rack with 18 mm holes (or 32 mm on request) and one "Straight head" (and a tubing kit). All other parts listed on Specifications site are optional and should be specified on order or may be purchased separately.

The straight head is delivered with a tubing kit composed of: 100 × Glass capillaries of an outside diameter 1.00 mm (Ref: GB 100TF 8P - thin wall with filament, ID = 0.78 mm, length: 8 cm, fire polished ends); Polyethylene tubing (5 m length, ID: 0.3, OD: 0.70 mm);  C-Flex tubing (7,5 m length, ID: 0.5 mm, OD: 2.1 mm);  9 × luer lock female; 9 × 10ml plastic syringe (or 50ml syringe on request); 2 × O-Rings