Back to: Syringe Warmers

Bubblestop

PrintShare
Syringe Warmer (AutoMate Scientific)
Automate Bubblestop  Syringe Warmer
Description

Bubbles in perfusion systems are caused by solution temperature changes. As solutions warm, they cannot hold as much gas, so they off-gas. This forms bubbles in perfusion tubing. It is especially true in inline heaters where the temperature rises dramatically. The best cure for bubbles is to pre-warm your solutions. AutoMate Scientific introduces the BubbleStop™ Syringe Heater with integrated temperature sensor and feedback. Set the temperature on the BubbleStop a few degrees higher than room temperature or your inline heater, and the warmed solutions will off-gas in the syringe reservoirs to the maximum gas concentration for that temperature. Even if they cool and re-heat again inside the perfusion tubing, they will not off-gas.

Note: the BubbleStop is NOT sufficient to warm solutions for delivery into a perfusion chamber without an inline heater like our ThermoClamp. The BubbleStop only helps stop bubbles.

 

BubbleStop™ Syringe Heater Available with gravity and pressurized syringes
BubbleStop™ Syringe Heater Available with gravity and pressurized syringes.